![]() ![]() Connect EVAP, ORVR, fuel and NVLD lines at front and rear of tank.ħ. Install and tighten bolts (1) (2) and (3). Refer to Fuel Pump Module Removal/Installation procedures.Ĥ. If fuel tank is to be replaced, install fuel pump module into tank. Refer to Fuel Pump Module Removal/Installation procedures.ġ. ![]() If fuel tank is to be replaced, remove fuel pump module from tank. Remove bolts (3) at left side of fuel tank.ĩ. Remove bolts (1) and (2) at right side of fuel tank.ħ. At front of tank, disconnect fuel and EVAP lines (9) and (10) from lines (11) and (12).Ħ. At rear of tank, disconnect EVAP lines (2) and (3) from lines (1) and (4).Ĥ. At rear of tank, disconnect fuel pump module electrical jumper connector (5) from body connector (6).ģ. Loosen clamp (9) and disconnect rubber fill hose (3) at tank fitting (7).Ģ. I will provide the directions for both tank removal and pump removal. The bad news is the tank needs removed to access the pump. If you find the pump is bad, here are the directions for replacement. Here are the manufacturer's specs for fuel pressure specific to your vehicle:įuel Pressure. Most parts stores will lend / rent you the fuel pressure gauge. It could be low, or the pump itself may be just going bad. With that, you need to check the fuel pressure to see what is going on. If it started with starting fluid, then it is a fuel related issue. Please run down this guide and report back. When you turn the key to the on position without cranking the engine over can you hear the fuel pump run in the tank for 5 seconds? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |